VHF R.AMP,3-4W IN-110W OUT,50-54 MHZ
Click Image For Larger Picture
A-1015-R$ 579.95 Each
|To see all Mirage Amps, please see Mirage Amps|
11 models to choose from - continuous duty all mode FM/SSB/CW repeater amplifiers for 6, 2, 220 MHz, 450 MHz, and ATV service.
50, 144 and 220 MHz Models
Cool Running - A10” high by 19” wide full finned rack-mounted heatsink keeps the transistor temperatures low for long life. Chassis cover is perforated so air convection will keep the circuit board area cool.
Dual Protection - The amplifiers have two temperature sensors; one on the heatsink and one on the circuit board. If conditions cause either to overheat, the amplifier will shut off until it cools down to a safe temperature.
Bypass Mode - These models will feed the exciter output straight through to the antenna in an over-temperature condition.
The bypass mode can also be remotely selected by proper interfacing to the repeater controller. Either a relay contact or a TTLlogic can be used to select the bypass mode or amplified mode of operation.
Reduced Relay Wear - The amps have a selectable long release time (adjustable up to 5 seconds) for the RF change-over relay. This prevents unnecessary action during repeater operation.
On-site Control - The bypass mode and relay release time can be selected with built-in switches. The operational MIRAGE RC-1 remote control box can be used to switch these functions up to 18 feet away from the amplifier.
Warranty - Mirage repeater amplifiers are guaranteed for one year against failure due to defective workmanship or materials.
Input Power Range: .25-5.
I (MAX) at 13.8 Volts: 20.
Weight in Pounds: 12.
Size WxHxD inches: 10x19 Heatsync.
PreAmp Gain: NO.
Typical Power Out for Watts in:
B-34-G2-M AMP, 2W-IN/35W OUT, GFET, FM/SSB/CW$139.95
KP-1/2MPRE-AMP,2-METER IN-SHACK,144-148 MHZ$149.95
KP-2/2MPRE-AMP,2-METER MAST-MOUNT,144-148 MHZ$199.95
B-1018-GVHF AMP,10W IN-160W OUT,144-148 MHZ$449.95